Adaptive Modules
Site Last Updated: Tuesday, February 5, 2008
MicrelNET Module
Adapt-MicrelNet
- Low footprint, customizable 4 layer stack, fully implemented on Adapt-Micrelnet node
- Frequency hopping, star networking topology
- Functions implemented via application layer or AT commands
- Easily customizable application layer, royalty free use, no membership required
Adapt-MicrelNet ISM Band Node
- Integrated eCOG1l MPU with Micrel’s advanced RF technology
- AT command interface via UART
- Full featured MicrelNet stack
- Small 50mm x 25mm form factor
- Optional LDO and TX/RX LEDs
- 868/915/434MHz options
- 2KM range (without amplification)
- 15-20kb/s (next gen to 200kb/a)
- Interface free, co-existence with 2.4Ghz Bluetooth & WLAN
- 3v to 3.6v to 2.5v to 3.6v supply
- Signal strength measurement and power control based on signal strength
- Production ready CE qualification imminent
- Connections brought out
- 5uA sleep mode current
- Low 16-20mA transceiver current
- No input terminations required
- EICE programming/debug signals (x5)
- General purpose IO (x8)
- Two x UARTs (x4) optional RTS/CTS (x4)
- 12 bit ADC input channels (x3)
- PWM output signals (x2)
There is also a development kit available:
Adapt-MicrelNet Decelopment Kit
- Supports the rapid programming of Adapt-MicrelNet nodes and networks
- Fully integrated with AdaptIDE complete software development environment with patented peripheral drag ‘n drop interface
- Programming and code debug performed via non-instrusive real-time eICE interface
- 3.3v power supply for Adapt-MicrelNet node provided from eICE debug connector
- USB/eICE adaptor included
- RS232 9 pin D type connector supports logging of network and node performance data
- RS232 9 pin D type to provide connection for Micrel RF Test Bench tools for RF evaluation